Turtur, C. (2008). An electrostatic rotor with a mechanical bearing. PHILICA.COM Observation number 45.
An electrostatic rotor with a mechanical bearing

Claus W. Turturconfirmed userThis person has donated to Philica (Fachbereich Elektrotechnik, University of Applied Sciences Braunschweig-Wolfenbuettel)

Published in physic.philica.com

In [1] the fundamentals of energy conversion from vacuum energy into mechanical energy have been experimentally verified with the use of an electrostatic rotor supported by a very special type of a hydrostatic bearing. The machine was now further developed to a mechanical toe-bearing, which is described here.

Final aim of the electrostatic rotor is the conversion of vacuum energy into mechanical energy for the use of technical energy production. The physical principle was demonstrated in [1], but the special type of hydrostatic bearing used there (with a rotor swimming on a water surface) is good for demonstration, not for industrial application. So the electrostatic rotor was built up with a toe bearing now, as used in radiometers, where the tip of a steel needle is in contact with a glass surface in order to minimize friction. A photo of this setup can be found at [2]. The rotor blades with an surface of 3.5cm x 6.0cm have been positioned within a distance of 3.8…4.0 cm away from the field source.
Tests with grounded rotor-blades and an electrically charged field source display the following results:
Field source brought to a potential of 1100 Volt – 4 revolutions per minute.
Field source brought to a potential of 1400 Volt – 12 revolutions per minute.
An experimental reproduction for the purpose of demonstration [3] with higher voltage shows a rotation going more rapid.
Prospects to the next step:
Up to now, no attention has been paid to leakage currents in the isolators, but now these losses should be minimized in order to get positive energy balance.

Observation circumstances
After the electrstatic rotor, which converts vacuum energy into mechanical energy is experimentally verified, this is the begin of the optimization with the aim of future technical benefit.

1. Turtur, C.W. (2008). Conversion of Vacuum-energy into mechanical energy: Successful experimental Verification. PHILICA.COM, Article no.124
2. http://public.rz.fh-wolfenbuettel.de/%7Eturtur/physik/Lichtmuehle_observation.pdf
3. The electrostatic rotor was demonstrated in both versions (1. with hydrostatic bearing and 2. with toe bearing) in the Physikalisch Technische Bundesanstalt, Braunschweig, Germany

Information about this Observation
This Observation has not yet been peer-reviewed

Published on Friday 11th April, 2008 at 13:02:15.

Creative Commons License
This work is licensed under a Creative Commons Attribution 2.5 License.
The full citation for this Observation is:
Turtur, C. (2008). An electrostatic rotor with a mechanical bearing. PHILICA.COM Observation number 45.

Website copyright © 2006-07 Philica; authors retain the rights to their work under this Creative Commons License and reviews are copyleft under the GNU free documentation license.
Using this site indicates acceptance of our Terms and Conditions.

This page was generated in 0.0082 seconds.